New extruder carriage with Lulzbot Budaschnozzle.
Old parts, cast extruder carriage, and wooden X and Y carriages.
Disassembly.
Reassembly, no belts installed at this point. Also the X and Y carriages are just slightly to long, Im hoping a quick trip to the belt sander will fix that issue.
At this time I have the belts installed. I still have to sand a little from the rear carriage, tighten up the set screws on the pulleys.
After a little more time I will run some gcode without the extruder hooked up just to break in the bearings.
At this time I have the belts installed. I still have to sand a little from the rear carriage, tighten up the set screws on the pulleys.
After a little more time I will run some gcode without the extruder hooked up just to break in the bearings.
No comments:
Post a Comment